Large 2-screw replacement handle for vintage Revere Ware pans

Price: $9.99
Product prices and availability are accurate as of 2017-12-17 09:32:22 UTC and are subject to change. Any price and availability information displayed on http://www.amazon.com/ at the time of purchase will apply to the purchase of this product.
Availability: In Stock
Usually ships in 24 hours
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED 'AS IS' AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.

Manufacturer Description

These are large sized replacement handles for vintage era Revere Ware pans. These parts are new and are made to look and work just like original Revere Ware handles.

Material: Bakelite, stainless steel

Includes: Two handle halves and hardware set

Measurements: 5.25 inch (130 mm) long, 3.1 inch (79 mm) between holes on center, fits a 3/4 inch metal spline.

How to fit: To determine the proper size handle make sure your sauce pan or skillet has a 3/4 inch tall metal spline, and has approximately 3.1 inches between the centers of the screw holes. If you have a 3/4" spline and 3.7" between the centers of the holes, you need the xtra large handle. For a 5/8" spline, you need the medium handle, and a 3/8" spline height, the small handle.

Possibly fits: Vintage era 7 inch pans, 8 inch skillets, 9 inch square skillets. These fit Revere Ware pans with handles that have two screws through the Bakelite.

Hardware Notes
The screws in the hardware set are Phillips head, not slotted like the original Revere Ware screw sets were. Because the original slot head screws strip very easily, we consider this an improvement.

Bakelite Notes
Bakelite is a great heat resistant material, but it can be a bit brittle. The most important thing is to not over tighten the screws when assembling the pan handle or you can crack the handle.
These parts are not oven safe. Washing in a dishwasher may dull the finish over time.

Installation Notes
We have seen about 5 percent of handles where the screw holes are off just enough to make it very hard to get the nuts to go all the way through. The is just a natural variation in the original Revere manufacturing process. A slight widening of the holes on the metal spline will allow the handles to fit.

Product Features

Large replacement handle for vintage Revere Ware pans Includes new screws and nuts

Write a Review